• Registered: 2014-04-22
  • Posts: 89

Topic: Error message

Could you please correct or tell me where to find the error, looked everywhere and been through the table many times.

Error: Table syssetting has no column named categoryname.

I have an FrmOrder with a dropdown field call categoryname (Orders.id_category), and a Button (BNewCat) going to FrmCatAdd, (ECatNam) and this as save Button (BAddCatOK) saved to to a dictionary called FrmSysSetDict (Gridsys1) many tabs in here.

Queries are all setup correctly, New Add button goes to FrmCatAdd, and OK buttons saves to FrmSysSetDict.

I hope I have give enough information to help me out.

  • Registered: 2014-08-02
  • Posts: 909

Re: Error message

Hello The Engineer

I've got such an error message (and many times !!).

Every time, when I used Save button, In action [Save Record], I forgot  choosing the fields
concerned by this action.

Or in the form, fields concerned by Save action were not filled (no TableName and no FieldName).
Obviously, Save button could not save fields unknown for it.

Is it the case for you ?

Good luck

Jean B.

  • Registered: 2014-02-14
  • Posts: 10,294

Re: Error message

The Engineer
Please, send me project to support@drive-software.com

Dmitry.