1 Topic by thezimguy (edited by thezimguy 2018-08-27 16:04:30)

  • Registered: 2018-07-19
  • Posts: 260

Topic: Problem with 'Naming of components'

Hello Dmitry and MVD users,
Please check this

1. Add any component to the form
2. Goto properties
3. Rename component (click no where on the properties after rename)
4. Click on form

After click on the form the name of the component is unset(goes back to previous name)
Unless after you click any where on the component panel before the new name will work when you rename a component.

Other properties work fine except the 'Name'

@thezimguy

thezimguy's Website

  • Registered: 2018-08-20
  • Posts: 20

Re: Problem with 'Naming of components'

Thank you thezimguy
I have also been facing the same issue. It delays renaming of the components. I wish DriveSoft will take a look at it.
Changing other properties is fine except the Name

  • Registered: 2014-11-13
  • Posts: 371

Re: Problem with 'Naming of components'

When you have named the component, move the check to another part and save

Domebil

domebil's Website

  • Registered: 2018-07-19
  • Posts: 260

Re: Problem with 'Naming of components'

domebil wrote:

When you have named the component, move the check to another part and save

Yeah I know of that but is that the default?
Other properties don't behave that way.
I'm able to save the name but it slow don't saving of the names

@thezimguy

thezimguy's Website

  • Registered: 2014-02-14
  • Posts: 10,294

Re: Problem with 'Naming of components'

You must to press Enter key.

Dmitry.